2.5.1.2. Check of a condition of a maple belt
Maple the belt cannot be tightened in addition. Within maintenance it is necessary to check it for absence of damage.
| PERFORMANCE ORDER |
| 1. Switch off ignition.
|
|
2. Mark a belt on well visible party cretaceous line. |
3. Turn an engine shaft by means of a replaceable face head of SW 27 on a pulley of a bent shaft in the direction of rotation of a shaft of the engine respectively on one part until there is visible a cretaceous mark again. At the same time install the transmission in neutral situation, tighten the hand lever of turning on of the parking brake system.
Prevention
Do not turn an engine shaft in the opposite direction.
|
4. Check maple a belt for existence of the following damages:
– wear of side surfaces: edges become peaked in the direction of a point (V), anew they take the trapezoid form;
– the pulling vein can be seen in the edge basis, it is especially visible on lighter places (C);
– cross cracks (D) on a reverse side of a belt;
– separate edges came off (lagged behind);
– the external pulling veins (F) obtrepatsya;
– the pulling veins sideways are pulled out (G);
– cross cracks (N) in some edges;
– ruptures of edges (J);
– separate cross cracks in edges of a belt (K);
– inclusions of dirt and stones between edges;
– rubber lumps in the basis of edges.
|
| 5. Replace maple a ridge belt if there are one or several defects.
|
|