1. When replacing keep in mind: the brake mechanism on both wheels of one axis has to have identical pistons of the same manufacturer. |
2. Forward brakes: put a support and tighten it to a nave two new самоконтрящимися bolts with m 115 N.' moment.
Prevention
If bolts go hard, clear a carving of the remains of fixing means by means of a tap of M 12х1,5.
|
3. Back brakes: put a support and fix two new самоконтрящимися by bolts on a nave with m 50 N.' moment, in cars with the ASR system – 70 N. m.
Prevention
If bolts go hard, clear a carving of the remains of fixing means by means of a tap of M 10.
|
|
4. If the brake hose was removed, screw it with m 15 N.' moment on a hydrowire. At installation the hose cannot be overwound. On an arm (52) the lock plate (60) with a dodecahedron is fixed. Insert a brake hose (51) into a lock plate so that it went freely at full turn of a wheel to the left and to the right, at compression and stretching of a spring of a suspension bracket. 4 - a hydrowire, 13 – the cap screw, 59 – an arm of a brake hose. |
5. Grease an opening for the ABS system speed sensor with means of Molykote Longtherm 2. Check a ring of round section, if necessary – replace. Put the speed sensor, having tightened it a new bolt with an internal hexagon with m 20 N.' moment, |
6. Connect a wire of the sensor of wear of slips to the socket on a support. |
7. If the brake system opened, pump over brakes. |
8. Put wheels so that the marking put before their removal coincided. Screw wheels. Remove the car from supports and tighten wheel bolts in a crosswise order with m 110 N.' moment.
Prevention
Vigorously repeatedly press on a brake pedal, you will not feel strong resistance yet. Thanks to it there is an adjustment of brake slips.
|
9. Check the level of brake fluid in a tank, if necessary add to the maximum mark.
Prevention
Carry out safety control: – whether brake hoses are tightened; – whether there is a brake hose in an arm; – whether pumping screws are tightened; – whether as it should be level of brake fluid
At the working engine make tightness control. For this purpose press a brake pedal with effort from 200 to 300 N (20–30 kg) within about 10 seconds. The pedal should not move. Check tightness of all connections.
|
10. In conclusion make several braking on the quiet street. |