8.1.7. Cross pipe of the air filter

PETROL ENGINE

Removal


PERFORMANCE ORDER
1. Extend the thermal sensor for the let-in air (B17) from a cross pipe, for this purpose squeeze the holding clips (shooter).
2. Screw collars (4/8), (4/13) and remove a cross pipe of the air filter (4/5) together with a shaped hose (4/6).

Installation

PERFORMANCE ORDER
1. 4-cylinder engine: get a cross pipe of the air filter so that both basing an element on the lower party were squeezed in the holding ledges on a casing of wires of the high voltage (arrow).
2. 6-cylinder engine: get a cross pipe of the air filter so that the welded-on hollow pins were pressed into rubber support of a cover of a head of the block of cylinders. Hollow pins serve for ventilation of a case of the engine and for fixation of a cross pipe.
3. Hardly tighten hose collars.
4. Install the thermal sensor for the let-in air (1B17) and squeeze out outside the holding clips until they are not recorded with click.

DIESEL ENGINE

Removal


PERFORMANCE ORDER
1. Unscrew bolts (97/3) on the inlet gas pipeline.
2. Unscrew bolts (97/2) from the holder (97/1) of a cross pipe of the air filter.
3. Remove a cross pipe of the air filter.

Installation

PERFORMANCE ORDER
1. Check for defects and porosity the condensing manzhetka (97/4) and sealing rings of a round profile on the hydrovalve case / to a cross pipe of the air filter, if necessary replace.
2. Insert a cross pipe of the air filter, install bolts in the inlet gas pipeline.
3. Screw the holder and tighten to the full bolts on the inlet gas pipeline.