8.1.10. Cable of management of gas (DB)

PETROL ENGINE


Prevention

The cable of management of gas is very sensitive to bends and therefore at installation it is necessary to handle with it especially with care. The only easy bend can lead to its breakage at operation of the car subsequently. Therefore curved cables should not be used at installation.


Removal


PERFORMANCE ORDER
1. Remove the directing element (30/5). At the same time at first extend from it the plastic nipple.
2. Unhook a cable (30) of management of gas. For this purpose remove through a cut in the kulisny lever (32/6) the hummock drive. Squeeze a plastic spring clip (30/4) and extend a cable on a support (32/3).
3. Remove the protection cover under the control panel.
4. Unhook fastening of the hummock drive on the accelerator lever. For this purpose extend the holder with an expansion bolt.
5. Squeeze out outside of internal space of the car a gas cable. At the same time do not put forward the rubber plug.
6. In a set remove a gas cable.

Installation

PERFORMANCE ORDER
1. Grease with anticorrosive Mercedes-000 989 87 5110 lubricant a gas cable between the directing element and a tip.
2. Check the rubber plug for absence of damage and porosity, otherwise replace.
3. Stretch a cable of management of gas in internal space of the car and hang it on the accelerator pedal lever.
4. Mount the protection cover under the control panel.
5. Enter through an opening in a support a cable of management of gas, press it into a support and record.
6. Hang a cable of management of gas together with the directing element. Pay attention to that the plastic nipple was fixed in the directing element.
7. Adjust a cable of management of gas.