3.2.4. Lower cover of a motor compartment
Prevention
At removal and installation do not damage the surface of protective material of a cover.
Removal
| PERFORMANCE ORDER |
| 1. Raise the car. |
|
2. Remove a forward covering (1), unscrew four bolts (arrow). |
| 3. Remove a back covering (2), having unscrewed eight bolts of fastening. If there is a need, remove a side covering at the left and on the right, having turned off respectively two bolts of fastening of a side covering to a longeron and one bolt of fastening to the lower support of the cross lever of an independent suspension bracket. |
|
Installation
| PERFORMANCE ORDER |
| 1. After dismantle establish a side covering and fix by bolts. |
| 2. Establish a back covering and fix by bolts. |
|
3. Establish a forward covering so that the groove in front entered a partition of a side part of a covering (3). |
|
4. Press a forward covering (1) up, at the same time the edge of a side part of a covering (3) has to be from above coverings (1). |
| 5. Tighten bolts of fastening of a forward covering. |
| 6. Lower the car on the earth. |
|