2. Clear pipelines of the brake drive low-temperature cleaning means.
Prevention
For protection against corrosion pipelines of the brake drive are covered with a film from synthetic polymer. If the film is damaged, then it can lead to corrosion of pipelines. For this reason it is impossible to clear pipelines of the brake drive a wire brush, a file or the screw-driver.
|
3. Lighting with a lamp, check pipelines of the brake drive from the main brake cylinder to separate wheel brake cylinders. The main brake cylinder is installed in a motor compartment under a tank with brake fluid.
Prevention
It is impossible neither to bend pipelines of the brake drive, nor to squeeze. They also should not have corrosion ulcers and points of attrition. Otherwise the pipeline going to the next place разъединениыя it is necessary to replace.
Brake hoses connect pipelines of the brake drive to wheel brake cylinders on moving details of the car. They consist of material, steady against high pressure, but eventually it can become porous, inflated or is cut by sharp objects. In that case these pipelines should be replaced immediately.
|
Bend manually to and fro brake hoses to establish whether there is a damage. These hoses cannot be twisted. Pay attention to the color designating strip! |
|
5. Places of connections of pipelines of the brake drive and brake hoses should not be humidified with the acting brake fluid.
Prevention
If the tank and consolidations are humidified with the acting brake fluid, then it not necessarily is the instruction on malfunction of the main brake cylinder. Most likely, brake fluid can filter through an air vent in a cover or through consolidation in a cover.
|