13.1.14. Glow lamps on the dashboard
A1. The combined device
e1. Signaling device of inclusion of indexes
left turn
e2. Signaling device of inclusion of indexes
right turn
e3. Signaling device of inclusion of indexes
tail light
e4. Alarm lamp of the index
fuel reserve
e5. Control of a charge of the rechargeable battery
e6. Control of wear of frictional slips
brake shoes
e7. Control of level of brake fluid and parking
brake system
e8. Illumination of a guard of devices
e9. Alarm lamp of seat belts
e11. Control of level of cooling liquid
e12. Control of level of oil
e13. Control of water level in a screen wiper 		e14. Control of failure of glow lamps
e15. Control of an inflatable safety cushion
e16. Control of a preliminary warming up
e17. Control of the antiblocking device of the brake system (ABS)
e21. Indication of functioning of system of regulation of slipping of driving wheels of rather basic surface (ASR)
e22. Control of system of regulation of slipping of driving wheels of rather basic surface (ASR)
e24. Control of the automatic blocked differential (ASO)
e25. Indication of functioning of the automatic blocked differential (ASD)
e26. Control of operation of the CHECK ENGINE engine
e34. EDC control

PERFORMANCE ORDER
1. Remove the dashboard.
2. If necessary remove cartridges of signaling devices on a reverse side by means of the left rotation and replace lamps. In auto repair shops of Mercedes for an otvorachivaniye of cartridges of lamps there is a special tool, but it can be executed also fingers or flat-nose pliers.
3. Replace a lamp only with the lamp having the identical power and the same type.
4. Insert a cartridge of a lamp and wrap it to the right.
5. Mount the dashboard.

SWITCH OF INDEXES OF TURN AND SWITCH OF THE SCREEN WIPER

Removal
31. Screws
32. Holder
33. Pipe cover casing
S4x1. The Shtekkerny socket of the combined switch		 S40x1. Shtekkerny socket of a tempomat
S4. The combined switch
S40. Switch of a tempomat

PERFORMANCE ORDER
1. Remove the protection cover under a guard of devices.
2. Remove a steering wheel.
Prevention

Follow rules of precaution at the handling of the device of an inflatable safety cushion.
3. Unscrew screws from a contact spiral at directly established forward wheels so that it was possible to remove a contact spiral.
Prevention

Do not unscrew completely screws, otherwise the contact spiral collapses and it will need to be established in average situation again.
4. Extend two shtekerny connections of a contact spiral from the holder and separate them. Remove a contact spiral.
5. Unscrew fixing screws to the combined switch.
6. Take the holder.
7. Take shtekkerny connection (S4x1) and way of shift бюгеля (arrow), deblock it.
8. Only at equipment tempomaty: Take and separate shtekkerny connection (S40x1).
9. Take a casing of a pipe cover (33) together with the combined switch, if necessary and the switch of a tempomat.

Installation

PERFORMANCE ORDER
1. Get on a steering shaft the combined switch together with a pipe cover.
2. Get and screw the holder.
3. Lay connecting lines and record tips of wires in the return sequence.
4. Get a contact spiral on a steering shaft, at the same time lay a connecting wire. Pay attention that the contact spiral is got against the stop and that the groove on a contact spiral coincides with the fixing ledge on a steering shaft. Tighten hardly fixing screws. Connect tips of wires and record them.
5. Install the protection cover under a guard of devices.
6. Establish a steering wheel.