12.8. Forward window regulator

Removal

PERFORMANCE ORDER
1. Remove an internal covering of a door.
2. Carefully remove the pressurizing film. Be careful: the film is easily torn.
3. Lower glass of a window as low as possible until the screw (2) appears in an assembly opening. (3 – the window regulator tire, 1 – glass.)
4. Unscrew the screw (2) in front on the window regulator tire.
5. Slightly raise glass behind and Take crackers from the window regulator tire.
6. Press glass up and insure it from loss by a plastic or wooden wedge.

7. Window regulator (4) приклепан. Drill 6 rivets (8) a drill 4, 8 mm. At the same time track that the drill did not enter an internal tin of a door. For a zaklepyvaniye pincers are necessary for secret rivets.
8. Extend a window regulator with the tire and take down. Take the power window together with the engine. Disconnect a window regulator wire.

Installation

PERFORMANCE ORDER
1. Establish a window regulator at a door and rivet by means of pincers for a secret klepka. If is not present at the disposal of pincers, then it is possible to fix a window regulator by screws and nuts. Cover screws before twisting with the protectant, for example, of Loctite 270 or Omnifit.
2. Carefully lower glass and enter together with crackers from the window regulator lever into a window regulator tire cut.
3. Insert the forward lever of a window regulator into the tire of the elevator and screw, without tightening. The screw (2) drags on only after the door window is adjusted.
4. Attach electric wires.
5. Adjust a door window.
6. Paste the pressurizing film so that there were no folds.
Prevention

Do not damage a film – it has to carry out sealing faultlessly.

7. Establish an internal covering of a door.