12.4. Handle of a forward door
1. Door handle
2. Lock cylinder guide
3. Rotary core
4. Laying
5. Laying		 6. A bolt with an internal hexagon of 4 mm
7. The holding bracket for a bolt
8. Basic bracket
9. Screws

Removal

PERFORMANCE ORDER
1. Get a door sealant at height of the door lock of a groove of a door.
2. Turn off approximately on 4 turns a bolt with an internal hexagon (6) by means of 4 mm of a face key through an opening at doors. The bolt with an internal hexagon is insured against drop-out by the holder (7).
3. (2) extend a guide at first back, and then outside.
4. Extend the door handle (1) with laying (4) from a basic bracket back and remove. The basic bracket can be removed, in case of need, from the inside of a door, but for this purpose it is necessary to remove a door covering.
5. Remove laying (5).

Installation

Door lock

 2 – lock cylinder guide
3 – rotary core
10 – eccentric adjusting screw
11 – door lock
12 – the operating lever

11 – door lock
13 – an opening under the eccentric adjusting screw
14 – an opening under the screw with an internal hexagon

PERFORMANCE ORDER
1. Install the eccentric regulating screw (10) outside thanks to what the door handle is easier mounted.
2. Install the door handle with laying and at the same time enter into the operating lever (12) of the door lock.
3. Behind insert a guide of the cylinder of the lock (2) and also enter a rotary core (3) into control of the door lock.
4. Fix the door lock by a bolt with an internal hexagon.
5. Adjust by means of the eccentric screw (10) a gap between the handle (1) and the operating lever (12) the crosswise screw-driver through an opening (13) on the forward party of a door. The gap has to make from 1 to 3 mm.
6. Insert a sealant of a door and check work of a door.